Accton Technology ES4626 - Manual (Page 632)

632
<ethernet> is the ethernet interface,
<vlan-id>
is VLAN ID;
<A.B.C.D> is the configured source IP addresses.
Default: Do not check
Command Mode: Global Mode
Usage Guide: The “no ip pim register-source” command restores the default value, no
more parameter is needed. Configured address must be reachable to Register-Stop
messages sent by RP. It’s usually a circle address, but it can be other physical addresses.
This address must be announcable through unicast router protocols of DR.
Example: Configure the source address sent by DR.
Switch (config)#ip pim register-source 10.1.1.1
16.3.3.15 ip pim register-suppression
Command: ip pim register-suppression <value>
no ip pim register-suppression
Function:
This command is to configure the value of register suppression timer, the unit
is second. The “no ip pim register-suppression” command restores the default value.
Parameter: <value> is the timer’s value, it ranges from 1 to 65535s.
Default: 60s
Command Mode: Global Mode
Usage Guide: If this value is configured at DR,it’s the value of register suppression timer;
if this value is configured at RP and ipv6 pim rp-register-kat is not used at RP, this
command modifies Keepalive-period value.
Example: Configure the value of register suppression timer to 10s.
Switch (config)#ip pim register- suppression 10
16.3.3.16 ip pim rp-address
Command: ip pim rp- address <A.B.C.D> <A.B.C.D/M>
no ip pim rp-address <A.B.C.D> [|]
Function:
This command is to configure static RP globally or in a multicast address
range.The “no ipv6 pim rp-address <A.B.C.D> [|]” command
cancels static RP.
Parameter: <A.B.C.D> is the RP address
<A.B.C.D/M> is the expected RP
<all> is all the range
Default: This switch is not a RP static router.
Command Mode:
Global Mode
Usage Guide: This command is to configure static RP globally or in a multicast address