Accton Technology ES4626 - Manual (Page 848)

848
Function: In the member switch, use this command to configure the commander switch.
Command mode:
Admin Mode
Instructions: This command is used to configure the commander switch remotely. Users
have to telnet the commander switch by passing the authentication. The command “exit”
is used to quit the configuration interface of the commander switch. If this command is
executed in the commander switch, an error will be displayed.
Example: In the member switch, enter the configuration interface of the commander
switch.
Switch#rcommand commander
22.1.3.9 cluster reset member
Command: cluster reset member
Function: In the commander switch, this command can be used to reset the member
switch.
Parameter: is the cluster ID of the member switch, valid rang is 1 to 23.
Command mode:
Admin Mode
Instructions: In the commander switch, users can use this command to reset a member
switch. If this command is executed in a non-commander switch, an error will be
displayed.
Example: In the commander switch, reset the member switch 16.
Switch#cluster reset member 16
22.1.3.10 cluster update member
Command: cluster update member [ascii | binary]
Function: In the commander switch, this command is used to remotely upgrade the
member switch.
Parameter: is the cluster ID of the member switch, valid rang is 1 to 23;
is the source path of the file which need to be copied; is the
destination path of the file which need to be copied; ascii means that the file is
transmitted in ASCII format; binary means that the file is transmitted in binary format.
When is a FTP address, its format is like: ftp: //:
@<ipaddress>/>. is the FTP user name,
is the FTP password, <ipaddress> is the IP address of the FTP server and is
the file name. When is a TFTP address, its format is like: tftp:
//<ipaddress>/. <ipaddress> is the IP address of the TFTP server and
is the file name.
The special keywords of filename:
Keyword Source address or destination address