Accton Technology ES4626 - Manual (Page 702)

702
Example: Configure vlan’s pim neighbor access-list
Switch (Config-if-Vlan1)#ipv6 pim neighbor-filter myfilter
Switch (Config)# ipv6 access-list myfilter deny fe80:20e:cff:fe01:facc
Switch (Config)# ipv6 access-list myfilter permit any
17.2.3.12 ipv6 pim register-rate-limit
Command: ipv6 pim Register-rate-limit
no ipv6 pim Register-rate-limit
Function: This command is used to configure the speedrate of DR sending register
packets, the unit is packet/second. the “no ipv6 pim Register-rate-limit” command
restores the default value. This configured speedrate is each（S, G）state’s, not the whole
systems.
Parameter: ranges from 1 to 65535
Default: No limit for sending speed
Command Mode:
Global Mode
Usage Guide: Configure the speedrate of DR sending register packets
Example: Configure the speedrate of DR sending register packets to 59 p/s
Switch(config)#ipv6 pim Register-rate-limit 59
17.2.3.13 ipv6 pim register-rp-reachability
Command: ipv6 pim Register-rp-reachability
no ipv6 pim Register-rp-reachability
Function: This command makes DR check the RP reachability in the process of
registration
Parameter: None
Default: Do not check
Command Mode: Global Mode
Usage Guide: This command configures DR whether or not to check the RP reachability.
Example:
Configure the router to check the RP reachability before sending register
packets.
Switch(config)# ipv6 pim Register-rp-reachability
17.2.3.14 ipv6 pim register-source
Command: ipv6 pim register-source {<source-address> |<ifname>}
no ipv6 pim register-source
Function: This command is to configure the source address of register packets sent by
DR to overwrite default source address. This default source address is usually the RPF