Accton Technology ES4626 - Manual (Page 441)

441
3）Configure the cost for sending packages from the interface
4）Configure OSPF package sending timer parameter (timer of broadcast interface
sending HELLO package to poll, timer of neighboring layer3 switch invalid
timeout, timer of LSA transmission delay and timer of LSA retransmission.
（ 2）Configure OSPF route introduction parameters
1）Configure default parameters (default type, default tag value, default cost
2）Configure the routes of the other protocols to introduce to OSPF.
（ 3）Configure other OSPF protocol parameters
1）Configure OSPF routing protocol priority
2）Configure cost for OSPF STUB area and default route
3）Configure OSPF virtual link
4）Configure the priority of the interface when electing designated layer3 switch
(DR).
3. Disable OSPF protocol
1. Enable OSPF protocol
Basic configuration of OSPF routing protocol on ES4624-SFP/ES4626-SFP switch is
quite simple, usually only enabling OSPF and configuration of the OSPF area for the
interface are required. The OSPF protocol parameters can use the default settings. If
OSPF protocol parameters need to be modified, please refer to “2. Configure OSPF
protocol parameters”.
Command Explanation
Global mode
[no] router ospf [process <id>]
Enables OSPF protocol; the “no router
ospf ” command disables OSPF protocol
(required)
OSPF protocol configuration mode
router-id
no router-id
Configures the ID number for the layer3
switch running OSPF; the “no router id”
command cancels the ID number. The IP
address of an interface is selected to be
the layer3 switch ID. (optional)
[no] network { |
/} area
Configure certain segment to certain area,
the no [no] network {
| /} area
command cancels this configuration.
(required)