Accton Technology ES4626 User Manual
Page 489
489
IPv6 ospf dead-interval
<time>
[instance-id
no IPv6 ospf dead-interval
[instance-id
Sets the interval before regarding a neighbor
layer3 switch invalid; the “no IPv6 ospf
dead-interval [instance-id
” command
restores the default setting.
IPv6 ospf transit-delay
<time>
[instance-id
no IPv6 ospf transit-delay
[instance-id
Sets the delay time before sending link-state
broadcast; the “no IPv6 ospf transit-delay
[instance-id
” command restores the
default setting.
IPv6 ospf retransmit
<time>
[instance-id
no IPv6 ospf retransmit
[instance-id
.Sets the interval for retransmission of
link-state advertisement among neighbor
layer3 switches; the “no IPv6 ospf
retransmit [instance-id
” command
restores the default setting.
（2）Configure OSPFv3 route introduction parameters
Configure OSPFv3 route introduction parameters
Commands Explanation
OSPF Protocol Configuration Mode
[no]redistribute {kernel |connected|
static| rip| isis| bgp} [metric
<value>]
[metric-type {1|2}][route-map
Introduces other protocol discovery
routing and static routing regarded as
external routing message. The
[no]redistribute {kernel |connected|
static| rip| isis| bgp} [metric
<value>]
[metric-type {1|2}][route-map
command cancels imported external
routing message.
（3） Configure Other Parameters of OSPFv3 Protocol
1） Configure OSPFv3 STUB Area & Default Routing Cost
2） Configure OSPFv3 Virtual Link
Commands Explanation
OSPFv3 Protocol Configuration Mode
timers spf
no timers spf
Configure OSPFv3 SPF timer. The no
timers spf
command recovers default
value.