Accton Technology ES4626 - Manual (Page 724)

724
ipv6 mld version ” command restores the manually configured version to the default one
Parameter:
is the version number of the MLD protocol,with a valid range
of 1-2.
Default: 2 by default
Command Mode: Interface Mode
Usage Guide: While there is routers still not upgraded to version 2 of MLD protocol on
the subnet connected, the interface should be configured to corresponding version.
Example: Configure the MLD version to 2.
Switch(Config)#ipv6 mld version 2
17.3.4 MLD Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch
B to corresponding vlan, and start PIM6 on each vlan interface.
Fig 17-3 Network Topology Diagram
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
Switch (Config) #ipv6 pim multicast-routing
Switch (Config) #ipv6 pim rp-address 3FFE::1
Switch (Config) #interface vlan 1
Switch (Config-If-Vlan1) #ipv6 address 3FFE::1/64
Switch (Config-If-Vlan1) #ipv6 pim sparse-mode
(2) Configure SwitchB:
Switch (Config) #ipv6 pim multicast-routing
Switch (Config) #ipv6 pim rp-address 3FFE::1
Switch (Config) #interface vlan1
Switch (Config-If-Vlan1) #ipv6 address 3FFE::2/64
Switch (Config-If-Vlan1) #ipv6 pim sparse-mode
Switch (Config-If-Vlan1) #exit
Switch (Config) #interface vlan2
SwitchB
Vlan 1 Vlan 1 Vlan 2
SwitchA