Accton Technology ES4626 - Manual (Page 276)

276
8.1.5.1.6 show mls-qos
Command: show mls-qos
Function: Displays global configuration information for QoS.
Parameters: N/A.
Default: N/A.
Command mode:
Admin Mode
Usage Guide: This command indicates whether QoS is enabled or not.
Example:
Switch #show mls-qos
Qos is enabled
Displayed information Explanation
Qos is enabled QoS is enabled.
8.2 PBR Configuration
8.2.1 Introduction to PBR
PBR（Policy-Based Routing）is a method which determines the next-hop of the data
packets by policy messages such as source address, destination address, IP priority,
TOS value, IP protocol, source port No., destination port No, etc.
8.2.2 PBR configuration
The PBR configuration task list is as follows:
Initiate PBR function
Enable or disable PBR function automatically when turn on or turn off the QoS
function at global mode.
Config classmap
Establish a class rule and apply different policies on different kinds of data streams
thereafter.
Config policymap
A policymap can be established after the data streams are classified. Assign each stream
to previously created classmap and then enter the policy classmap mode. In this way
different data streams can now be assigned to different next-hop IP address and apply
the policy to the port.
Apply policymap