Accton Technology ES4626 - Manual (Page 634)

634
item will be obsolete.
Example:
Configure the kat value of RP’s (S,G) item to 180s
Switch (config)#ip pim rp-register- kat 180
Switch (config)#
16.3.3.19 ip pim sparse-mode
Command: ip pim sparse-mode [passive]
no ip pim sparse-mode [passive]
Function:
Enable PIM-SM on the interface; the “no ip pim sparse-mode [passive]”
command disables PIM-SM.
Parameter: [passive] means to disable PIM-SM (that’s PIM-SM doesn’t receive any
packets) and only enable IGMP(reveice and transmit IGMP packets).
Default: Do not enable PIM-SM
Command Mode: Interface Configuration Mode
Usage Guide: Enable PIM-SM on the interface.
Example:
Enable PIM-SM on the interface vlan1.
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ip pim sparse-mode
Switch(Config-If-Vlan1)#
16.3.3.20 ip pim ssm
Command: ip pim ssm {default|range <access-list-number >}
no ip pim ssm
Function: Configure the range of pim ssm multicast address. The “no ip pim ssm”
command deletes configured pim ssm multicast group.
Parameter: default : indicates the default range of pim ssm multicast group is 232/8.
<access-list-number > is the applying access-list number, it ranges from 1 to 99.
Default: Do not configure the range of pim ssm group address
Command Mode: Global Mode
Usage Guide:
1. Only this command is configured, pim ssm can be available.
2. Before configuring this command, make sure ip pim multicasting succeed. This
command can’t work with DVMRP.
3. Access-list can’t used the lists created by ip access-list, but the lists created by
access-list.
4.Users can execute this command first and then configure the corresponding acl; or
delete corresponding acl in the bondage. After the bondage, only command no ip pim
ssm can release the bondage.