Accton Technology ES4626 User Manual

Page 87

used to connect PC to the management port on the switch. The PC should have

FTP/TFTP server software installed and has the image file required for the upgrade.

Step 2:

Press “ctrl+b” on switch boot up until the switch enters BootROM monitor mode. The

operation result is shown below:

ES4626-SFP Management Switch

Reset chassis ... done.

Testing RAM...

134,217,728 RAM OK.

Loading BootROM...

Starting BootRom...

Attaching to file system ... done.

BootRom version: 1.0.4

Creation date: Jun 9 2006, 14: 54: 12

Attached TCP/IP interface to lnPci0.

[Boot]:

Step 3:

Under BootROM mode, run “setconfig” to set the IP address and mask of the switch

under BootROM mode, server IP address and mask, and select TFTP or FTP upgrade.

Suppose the switch address is 192.168.1.2/24, and PC address is 192.168.1.66/24, and

select TFTP upgrade, the configuration should like:

[Boot]: setconfig

Host IP Address: 10.1.1.1 192.168.1.2

Server IP Address: 10.1.1.2 192.168.1.66

FTP(1) or TFTP(2): 1 2

Network interface configure OK.

[Boot]:

This manual is related to the following products: