5 dns-server, 6 domain-name, 7 hardware-address – Accton Technology ES4626 User Manual
Page 324
324
Function:
Configures default gateway(s) for DHCP clients; the “no default-router”
command deletes the default gateway.
Parameters:
address1…address8 are IP addresses, in decimal format.
Default:
No default gateway is configured for DHCP clients by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
The IP address of default gateway(s) should be in the same subnet as the
DHCP client IP, the switch supports up to 8 gateway addresses. The gateway address
assigned first has the highest priority, and therefore address1 has the highest priority, and
address2 has the second, and so on.
Example:
Configuring the default gateway for DHCP clients to be 10.1.128.2 and
10.1.128.100.
Switch(dhcp-1-config)#default-router 10.1.128.2 10.1.128.100
10.2.2.5 dns-server
Command: dns-server
no dns-server
Function:
Configure DNS servers for DHCP clients; the “no dns-server” command
deletes the default gateway.
Parameters:
address1…address8 are IP addresses, in decimal format.
Default:
No DNS server is configured for DHCP clients by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
Up to 8 DNS server addresses can be configured. The DNS server
address assigned first has the highest priority, Therefore address 1 has the highest
priority, and address 2 has the second, and so on.
Example:
Set 10.1.128.3 as the DNS server address for DHCP clients.
Switch(dhcp-1-config)#dns-server 10.1.128.3
10.2.2.6 domain-name
Command:domain-name
no domain-name
Function:
Configures the Domain name for DHCP clients; the “no domain-name”
command deletes the domain name.
Parameters:
Command Mode:
DHCP Address Pool Mode
Usage Guide:
Specifies a domain name for the client.
Example:
Specifying “edgecore.com" as the DHCP clients’ domain name.
Switch(dhcp-1-config)#domain-name edgecore.com
10.2.2.7 hardware-address