Accton Technology ES4626 - Manual (Page 378)

378
Function: Configure the origin ip address of the BGP routing message. The “no set
originator-id [>]
” command deletes the configuration.
Parameter: > is the ip address of the route source shown by dotted decimal
notation.
Command Mode: route-map mode
Usage Guide: To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set originator-id 10.1.1.1
13.2.3.24 set tag
Command: set tag >
no set tag [>]
Function: Configure the tag domain of OSPF routing messages. The “no set tag
[>]
” command deletes this configuration.
Parameter: <tag-val > is the tag value, ranging between 0～4294967295.
Command Mode: route-map mode
Usage Guide: There is a route-tag domain at the AS-external-LSA type LSA. The domain
is normally identified by other routing protocols. To use this command, one match clause
should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set tag 60
13.2.3.25 set vpnv4 next-hop
Command: set vpnv4 next-hop >
no set vpnv4 next-hop [>]
Function:
Configure the next-hop of BGP VPNv4 routing message. The “no set vpnv4
next-hop [>] ” command deletes the configuration.
Parameter: > is the next-hop ip address of VPNv4 route shown by dotted
decimal notation.
Command Mode: route-map mode
Usage Guide: To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5