Accton Technology ES4626 - Manual (Page 451)

451
13.6.3.13 distance
Command: distance {<value>|ROUTEPARAMETER}
no distance osp f
Function: Configure OSPF manage distance base on route type. The “no distance
osp f” command restores the default value.
Parameter: <value>,
OSPF routing manage distance, ranging between 1~235
ROUTEPARAMETER= ospf {ROUTE1|ROUTE2|ROUTE3}
ROUTE1= external , Configure the distance learnt from other
routing area.
distance value, ranging between 1~255
ROUTE2= inter-area , configure the distance value from one area to
another area.
manage distance value, ranging between 1~255
ROUTE3= intra-area Configure all distance values in one area.
Manage distance value, ranging between 1~255
Default: Default distance value is 110
Command Mode: OSPF protocol mode
Usage Guide: Manage distance shows the reliability of the routing message source.
The distance value may range between 1~255. the larger the manage distance value is,
the lower is its reliability.
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#distance ospf inter-area 20 intra-area 10 external 40
13.6.3.14 distribute-list
Command: distribute-list out {kernel |connected| static| rip|
isis| bgp}
[no] distribute-list out {kernel |connected| static| rip| isis| bgp}
Function: Filter network in the routing update. The “[no] distribute-list out {kernel
|connected| static| rip| isis| bgp} ” command disables this function.
Parameter:< access-list-name> is the access-list name to be applied
out: Filter the sent route update
kernel Kernel route
connected Direct route
static Static route
rip RIP route
isis ISIS route