Accton Technology ES4626 - Manual (Page 721)

721
Function: Configure the interface’s timeout of MLD queries; the “no ipv6 mld
query-timeout
” command restores the default value
Parameter: <time_val> is the timeout of MLD queries, it ranges from 60 to 300s
Default: 255s
Command Mode: Interface Configuration Mode
Usage Guide: In the share network, when there are more switches that run MLD,one
switch will be selected as the querying host and others set a timer to inspect the querying
host’s state. If no querying packet is received when the timeout is over, a switch will be
reselected as the querying host .
Example: Configure the interface’s timeout of MLD queries to 100s
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ipv6 mld query-timeout 100
17.3.3.7 ipv6 mld access-group
Command: ipv6 mld access-group {<acl_name>}
no ipv6 mld access-group
Function: Configure the filter conditions of the interface on the MLD group; the “no ipv6
mld access-group ” ommand cancels the filter conditions.
Parameter: is the name of the IPv6 access list
Default: No filter condition by default
Command Mode: Interface Mode
Usage Guide: This command can configure the filter on the interface to the groups,
permitting or denying certain groups.
Example: Configure the interface vlan1 to permit group FF1E::1:0/112, while denying all
others.
Switch (Config)# ipv6 access-list aclv6 permit FF1E::1:0/112
Switch (Config)# ipv6 access-list aclv6 deny any
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ipv6 mld access-group aclv6
17.3.3.8 ipv6 mld join-group
Command: ipv6 mld join-group
no ipv6 mld join-group
Function: Configure the interface to join in certain multicast group; the “no ipv6 mld
join-group ” command cancels joining certain multicast group.
Parameter: is a valid IPv6 multicast address
Default:
No multicast group joined by factory default
Command Mode: Interface Mode