Accton Technology ES4626 - Manual (Page 29)

29
Mode. Mode.
1.2.2.8 ACL Mode
ACL type Entry Prompt Operates Exit
Standard IP
ACL Mode
Type
access-list ip
command
under Global
Mode.
Switch(Config-Std-Nacl-
a)#
Configure
parameters
for
Standard
IP ACL
Mode
Use the “exit”
command to
return to
Global Mode.
Extended IP
ACL Mode
Type
access-list ip
command
under Global
Mode.
Switch(Config-Ext-Nacl-
b)#
Configure
parameters
for
Extended
IP ACL
Mode
Use the “exit”
command to
return to
Global Mode.
1.2.3 Configuration Syntax
ES4624-SFP/ES4626-SFP Switch provides various configuration commands.
Although all the commands are different, they all abide by the syntax for
ES4624-SFP/ES4626-SFP Switch configuration commands. The general commands
format of ES4624-SFP/ES4626-SFP Switch is shown below:
cmdtxt { enum1 | … | enumN } [option]
Conventions: cmdtxt in bold font indicates a command keyword; indicates a
variable parameter; {enum1 | … | enumN } indicates a mandatory parameter that should
be selected from the parameter set enum1~enumN; and the square bracket ([ ]) in
[option] indicate an optional parameter. There may be combinations of “< >“, “{ }” and
“[ ]” in the command line, such as [],{enum1 | enum2}, [option1
[option2]], etc.
Here are examples for some actual configuration commands:
z show calendar , no parameters required. This is a command with only a keyword
and no parameter, just type in the command to run.
z vlan <vlan-id> , parameter values are required after the keyword.
z duplex {auto|full|half} , user can enter duplex half, duplex full or duplex auto for this