Accton Technology ES4626 - Manual (Page 766)

766
Parameters: : name of access-list excluding blank or quotation mark, and it must
start with letter, and the length cannot exceed 16 (remark: sensitivity on capital or small
letter.)
Command Mode: Global mode
Default: No named MAC-IP access-list
Usage Guide:After assigning this commands for the first time, only an empty name
access-list is created and no list item included.
Examples: Create an MAC-IP ACL named mac. acl
Switch(Config)# mac-ip-access-list extended macip_acl
Switch(Config-MacIp-Ext-Nacl-macip_acl)#
18.2.2.19 permit | deny( ip extended)
Command: [no] {deny | permit} icmp {{ } | any | {host
}} {{ } | any-destination | {host-destination
}} [ []] [precedence ] [tos
][time-range]
[no] {deny | permit} igmp {{ } | any | {host }}
{{ } | any-destination | {host-destination }}
[] [precedence ] [tos ][time-range]
[no] {deny | permit} tcp {{ } | any | {host }}
[s-port ] {{ } | any-destination | {host-destination
}} [d-port ] [ack+fin+psh+rst+urg+syn] [precedence ] [tos
][time-range]
[no] {deny | permit} udp {{ } | any | {host }}
[s-port ] {{ } | any-destination | {host-destination
}} [d-port ] [precedence ] [tos
][time-range]
[no] {deny | permit} {eigrp | gre | igrp | ipinip | ip | } {{
} | any | {host }} {{ } | any-destination |
{host-destination }} [precedence ] [tos
][time-range]
Functions: Create a name expansion IP access rule to match specific IP protocol or all
IP protocol;
Parameters: is the source IP address, the format is dotted decimal notation;
<sMask > is the reverse mask of source IP, the format is dotted decimal notation;
is the destination IP address, the format is dotted decimal notation; <dMask>
is the reverse mask of destination IP, the format is dotted decimal notation, attentive
position o, ignored position 1; <igmp-type>, the type of igmp, 0-15; , the