Accton Technology ES4626 - Manual (Page 490)

490
area <id> stub [no-summary]
no area <id> stub [no-summary]
area <id> default-cost <cost>
no area <id> default-cost
area
<id> virtual-link A.B.C.D
[instance-id <instance-id> INTERVAL]
no area <id> virtual-link A.B.C.D
[|INTERVAL]
Configure parameters in OSPFv3
area (STUB area, Virtual link). The no
command restores default value.
4）Configure the priority of the interface when electing designated layer3 switch (DR).
Commands Explanation
Interface Configuration Mode
IPv6 ospf priority
<priority>
[instance-id ]
no IPv6 ospf priority [instance-id
]
Sets the priority of the interface in “designated
layer3 switch” election; the “no IPv6 ospf
priority [instance-id ] ” command
restores the default setting.
3. Disable OSPFv3 Protocol
Commands Explanation
Global mode
no router IPv6 ospf [] Disable OSPFv3 Routing Protocol
13.7.3 Commands for OSPFV3
13.7.3.1 area default cost
Command: area <id> default-cost <cost>
no area <id> default-cost
Function: Configure the cost of sending to the default summary route in stub or NSSA
area; the “no area <id> default-cost” command restores the default value.
Parameter: <id> is the area number which could be shown as digits 0～4294967295, or
as an IP address; <cost> ranges between <0-16777215>
Default: Default OSPFv3 cost is 1
Command Mode: OSPFv3 protocol mode
Usage Guide: The command is only adaptive to the ABR router connected to the stub