Accton Technology ES4626 - Manual (Page 423)

423
1. Enable RIPng protocol (required)
（ 1） Enable/disable RIPng protocol
（ 2） Configure the interfaces running RIPng protocol
2. Configure RIPng protocol parameters (optional)
（ 1） Configure RIPng sending mechanism
1) Configure specified RIPng packets transmission address
（ 2） Configure RIP routing parameters
1) Configure route introduction (default route metric, configure routes of the
other protocols to be introduced in RIPng)
2) Configure the route deviation
3) Configure and apply route filter
4) Configure split horizon
（ 3） Configure other RIPng parameters
1） Configure timer for RIPng update, timeout and hold-down
（ 4） Delete the specified route in RIPng route table
1. Enable RIPng protocol
Applying RIPng route protocol with basic configuration in ES4624-SFP/ES4626-SFP
switch is simple. Normally you only have to open the RIPng switch and configure the
segments running RIPng, namely send and receive the RIPng data packet by default
RIPng configuration.
Command Explanation
Global mode
[no] router IPv6 rip
Enables the RIPng protocol; the [no] router
IPv6 rip command shuts the RIPng protocol.
Interface configuration mode
[no] IPv6 router rip
configure the interface to run RIPng protocol;
the [no] IPv6 router rip command set the
interface not run RIPng protocol
2. Configure RIPng protocol parameters
（1）Configure RIPng sending mechanism
1）configure the RIPng data packets point-transmitting
Command Explanation
Router configuration mode