Accton Technology ES4626 - Manual (Page 271)

271
Switch(Config-PolicyMap)#class c1
Switch(Config--Policy-Class)#set ip precedence 5
Switch(Config--Policy-Class)#exit
Switch(Config-PolicyMap)#exit
Switch(Config)#interface ethernet 1/1
Switch(Config-Ethernet1/1)#service-policy input p1
QoS configuration in SwitchB:
SWITCH#CONFIG
Switch(Config)#mls qos
Switch(Config)#interface ethernet 1/1
Switch(Config-Ethernet1/1)#mls qos trust ip-precedence pass-through-cos
8.1.5 QoS Troubleshooting
z QoS is disabled on switch ports by default, 8 sending queues are set by default,
queue1 forwards normal packets, other queues are used for some important control
packets (such as BPDU).
z When QoS is enabled in Global Mode,. QoS is enabled on all ports with 8 traffic
queues. The default CoS value of the port is 0; the port is in not Trusted state by
default; the default queue weight values are 1, 2, 3, 4, 5, 6, 7, 8 in order, all QoS Map
is using the default value.
z CoS value 7 maps to queue 8 that has the highest priority and usually reserved for
certain protocol packets. It is not recommended for the user to change the mapping
between CoS 7 to Queue 8, or set the default port CoS value to 7.
z Policy map can only be bound to ingress direction, egress is not supported yet.
z If the policy is too complex to be configured due to hardware resource limit, error
massages will be provided.
8.1.5.1 Commands for Monitor And Debug
8.1.5.1.1 show class-map
Command: show class-map [<class-map-name>]
Function: Displays class map of QoS.
Parameters: < class-map-name> is the class map name.
Default: N/A.
Command mode:
Admin Mode
Usage Guide: Displays all configured class-map or specified class-map information.