Accton Technology ES4626 - Manual (Page 414)

414
Fig 13-4 RIP VPN example
In the figure shown above, a network consists of three Layer 3 switches, in which the
SwitchA as PE, SwitchB and SwitchC as CE1 and CE2. The PE is connected to CE1 and
CE2 through vlan 1 and vlan 2. The routing messages are exchanged between PE and
CE through RIP protocol.
a) Switch, the Layer 3 switch of PE
Configures the VPN route/transmit example vpnb and vpnc
SwitchA#config
SwitchA(config)#ip vrf vpnb
SwitchA(config-vrf)#
SwitchA(config-vrf)#exit
SwitchA#(config)
SwitchA(config)#ip vrf vpnc
SwitchA(config-vrf)#
SwitchA(config-vrf)#exit
associate the vlan 1and vlan 2 respectively with vpnb and vpnc while configuring IP
address
SwitchA(config)#in vlan1
SwitchA(config-if-Vlan1)#ip vrf forwarding vpnb
SwitchA(config-if-Vlan1)#ip address 10.1.1.1 255.255.255.0
SwitchA(config-if-Vlan1)#exit
SwitchA(config)#in vlan2
SwitchA(config-if-Vlan2)#ip vrf forwarding vpnc
SwitchA(config-if-Vlan2)#ip address 20.1.1.1 255.255.255.0
SwitchA(config-if-Vlan2)#exit
Configures the RIP examples associated with vpnb and vpnc respectively
SwitchA(config)#
SwitchA(config)#router rip
SwitchA(config-router)#address-family ipv4 vrf vpnb
SwitchA(config-router-af)#redistribute bgp
SwitchA
SwitchC
Interface
Vlan2:20.1.1.2/24
vlan1:10.1.1.2/24
Interface
vlan1:10.1.1.1/24
Interface
vlan2:20.1.1.1/24
Interface
SwitchB