Accton Technology ES4626 - Manual (Page 195)

195
Function: Add the correspondence between MAC address and VLAN, namely specify
certain MAC address to join specified VLAN. The “no” form of this command deletes
all/the correspondence.
Parameter: mac-address is the MAC address which is shown in the form of
XX-XX-XX-XX-XX-XX,vlan-id is the ID of the VLAN with a valid range of
1~4094;priority-id is the level of priority and is used in the VLAN tag with a valid range of
0~7;all refers to all the MAC addresses.
Command Mode: Global Mode
Default:
No MAC address joins the VLAN by default.
Usage Guide: With this command user can add specified MAC address to specified
VLAN. If there is a non VLAN label data packet enters from the switch port from the
specified MAC address, it will be assigned with specified VLAN ID so sent enter specified
VLAN. Their belonging VLAN are the same no matter which port did they enter through.
The command does not have any interfere on the VLAN label data packet
Example:
Switch#config
Switch(config)#mac-vlan mac 00-03-0f-11-22-33 vlan 100 priority 0
5.5.2.2.4 protocol-vlan
Command: protocol-vlan mode {ethernetii etype |llc {dsap
ssap }|snap etype } vlan
no protocol-vlan {mode {ethernetii etype |llc {dsap
ssap }|snap etype }|all}
Function: Add the correspondence between the protocol and the VLAN namely specify
the protocol to join specified VLAN. The “no” form of this command deletes all/the
correspondence
Parameter: Mode is the encapsulate type of the configuration which is ethernetii、llc、
snap;the encapsulate type of the ethernetii is EthernetII;etype-id is the type of the packet
protocol, with a valid range of 1536~65535;llc is LLC encapsulate format;dasp-id is the
access point of the destination service, the valid range is 0~255;aasp-id is the access
point of the source service with a valid range of 0~255;snap is SNAP encapsulate
format;etype-id is the type of the packet protocol, the valid range is 1536~65535;vlan-id is
the ID of VLAN, the valid range is 1~4094;all indicates all the encapsulate protocols.
Command Mode: Global Mode
Default: No protocol joined the VLAN by default
Usage Guide: The command adds specified protocol into specified VLAN. If there is any
non VLAN label packet from specified protocol enters through the switch port, it will be
assigned with specified VLAN ID and enter the specified VLAN. No matter which port the
packets go through, their belonging VLAN is the same. The command will not interfere
with VLAN labeled data packets. It is recommended to configure ARP protocol together