Accton Technology ES4626 - Manual (Page 543)

543
Example:
Switch(config)# mpls disable-all-interfaces
13.8.3.41 neighbor activate
Command: neighbor {|} activate
no neighbor {|} activate
Function: Configure the address family routing which do or do not switch specific
address-family with BGP neighbors. The “no neighbor {|} activate”
command is for setting the route which do not switch the specified address family
Parameter: : IP address of the neighbor
: Name of peer group
Default: Enable the routing switch of IP unicast address-family, and disable other
address-families
Command Mode: BGP route mode and address-family mode
Usage Guide: IP unicast is configured under BGP route mode. Configure whether
specific address-family is switched under address-family mode. If this option on any side
between local side and partner is not enabled, the address-family route will not be
acquired by the partner even if the corresponding address family routes acquired before
will be cancelled after this option is disabled.
Example:
Switch(config-router)#neighbor 10.1.1.64 activate
Switch(config-router)#address-family ipv4
Switch(config-router-af)#no neighbor 10.1.1.64 activate
Switch(config-router-af)#
13.8.3.42 neighbor advertisement-interval
Command: neighbor {|} advertisement-interval <0-600>
no neighbor {|} advertisement-interval [<0-600>]
Function: Configure the update interval of specific neighbor route. the “no neighbor
{|} advertisement-interval [<0-600>]
” command restores to default
Parameter: : IP address of the neighbor
: Name of the peer group
<0-600>: Advertise interval, in seconds
Default: Default IBGP is 5s, default EBGP is 30s
Command Mode: BGP route mode and address-family mode
Usage Guide: Reduce this value will improve the route updating speed while also
consumes more bandwidth.
Example: