Accton Technology ES4626 - Manual (Page 488)

488
router-id
no router-id
Configure router for ospfv3 process. The
no router-id command returns ID to
0.0.0.0 (required)
[no] passive-interface
Configure an interface receiving without
sending. The [no]
passive-interface
command
cancels configuration.
Interface Configuration Mode
[no] IPv6 router ospf
{area
[instance-id | tag
[instance-id ]] | tag
area [instance-id
]}
Implement ospfv3 routing on the interface.
The [no] IPv6 router ospf {area
[instance-id | tag
[instance-id ]] | tag
area [instance-id
]} command cancels
configuration.
2. Configure OSPFv3 parameters
（1）Configure OSPFv3 package sending mechanism parameters
1）Set the OSPF interface to receive only
2）Configure the cost for sending packages from the interface
Commands Explanation
Interface Configuration Mode
IPv6 ospf cost [instance-id
]
no IPv6 ospf cost [instance-id
]
Appoint interface to implement required cost
of OSPFv3 protocol. The no IPv6 ospf cost
[instance-id ] restores the default setting
3）Configure OSPFv3 package sending timer parameter (timer of broadcast interface
sending HELLO package to poll, timer of neighboring layer3 switch invalid timeout, timer
of LSA transmission delay and timer of LSA retransmission.
Commands Explanation
Interface Configuration Mode
IPv6 ospf hello-interval <time>
[instance-id ]
no IPv6 ospf hello-interval
[instance-id ]
Sets interval for sending HELLO packages;
the “no IPv6 ospf hello-interval [instance-id
] ” command restores the default setting.