Accton Technology ES4626 - Manual (Page 500)

500
13.7.3.19 router ipv6 ospf
Command: [no] router ipv6 ospf []
Function: This command initializes the ospfv3 routing prcess and enters ospfv3 mode for
configuring the ospfv3 routing process. The “[no] router ipv6 ospf []” command
stops relevant process
Parameter:
ospfv3 is the process mark which could be random strings made up of
characters and digits
Command Mode: Global mode
Usage Guide: To let he ospfv3 routing process work properly, this command must be
configured and ospfv3 must at least be enabled on one interface. When the tag
configured by the ipv6 router ospf area command under interface mode matches with the
tag of ospf process, the ospfv3 process is enabled on this interface.
Example:
Switch#config terminal
Switch(config)#router ipv6 ospf IPI
13.7.3.20 timers spf
Command: timers spf
no timers spf
Function: Adjust route calculation timer value. The “no timers spf” restores the relevant
value to default
Parameter: 5 seconds by default
10 seconds by default
Command Mode: OSPFv3 protocol mode
Usage Guide: In this command the delay time between receiving topology change and
SPF calculation, and further configured the hold time between two discontinuous SPF
calculations.
Example:
Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#timers spf 5 10
13.7.4 OSPFv3 Examples
Examples 1:OSPF autonomous system.
This scenario takes an OSPF autonomous system consists of five
ES4624-SFP/ES4626-SFP switch for example, where layer3 SwitchA and SwitchD make
up OSPF area 0, layer3 Switch2 and Switch3 form OSPF area 1 (assume vlan1
interface of layer3 SwitchA belongs to area 0), layer3 SwitchD forms OSPF area2
(assume vlan2 interface of layer3 SwitchD belongs to area 0). Swtich1 and SwitchD are