Accton Technology ES4626 - Manual (Page 132)

132
2. Configure the properties for the Ethernet ports
Command Explanation
Interface Mode
combo-forced-mode { copper-forced
| copper-preferred-auto | sfp-forced |
sfp-preferred-auto }
no combo-forced-mode
Sets the combo port mode (combo ports
only);the “no combo-forced-mode”
command restores the default combo
mode for combo ports, i.e, fiber ports first.
shutdown
no shutdown
Enables/Disables specified ports
name
no name
Names or cancels the name of specified
ports
mdi { auto | across | normal }
no mdi
Sets the cable type for the specified port
speed-duplex{auto|force10-half|forc
e10-full|force100-half|force100-full|{{
force1g-half|force1g-full}[nonegotiat
e[master|slave]] } }
Sets port speed and duplex mode of
100/1000Base-TX ports. The “no” format
of this command restores the default
setting, i.e., negotiates speed and duplex
mode automatically.
negotiation {on|off}
Enables/Disables the auto-negotiation
function of 1000Base-T ports.
rate-limit {input|output}
no rate-limit {input|output}
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports
flow control
no flow control
Enables/Disables traffic control function for
specified ports
loopback
no loopback
Enables/Disables loopback test function
for specified ports
Command Explanation
Interface Mode
interface ethernet
Enters the network port configuration
mode.