Accton Technology ES4626 - Manual (Page 844)

844
4. Configure attributes of the cluster in the candidate switch
5. Remote cluster network management
22.1.3 Commands for cluster
22.1.3.1 cluster run
Command: cluster run
Command Explanation
Global Mode
cluster auto-add enable
no cluster auto-add enable
Enable or disable adding newly discovered
candidate switch to the cluster
cluster holdtime < second>
no cluster holdtime
Set holdtime of heartbeat of the cluster
cluster heartbeat
no cluster heartbeat
Set interval of sending heartbeat packets
among the switches of the cluster
clear cluster candidate-table
Clear the list of candidate switches
discovered by the commander switch
Command Explanation
Global Mode
cluster register timer
no cluster register timer
Set interval of sending cluster register
packet
Command Explanation
Admin Mode
rcommand member
In the commander switch, this
command is used to configure and
manage member switches.
rcommand commander
In the member switch, this command is
used to configure the member switch
itself.
cluster reset member
In the commander switch, this
command is used to reset the member
switch.
cluster update member
[ascii | binary]
In the commander switch, this
command is used to remotely upgrade
the member switch.