15 tunnel source, 16 tunnel destination, 17 tunnel nexthop – Accton Technology ES4626 User Manual
Page 294
294
Success rate is 100 percent (1/1), round-trip min/avg/max = 1/1/1 ms
Displayed information
Explanation
ping6
Execute ping6 function
Target IPv6 address
Destination IPv6 address
Repeat count
Number of ping packets being sent
Datagram size in byte
Size of Ping packets
Timeout in milli-seconds
Time delay allowed
Extended commands
Settings of extensive parameters
! Indicate
that
the
network is reachable
Success rate is 100 percent (1/1),
round-trip min/avg/max = 1/1/1 ms
Statistics information, which shows the rate
of ping packets arriving successfully is
100%, no loss.
9.2.2.3.1.15 tunnel source
Command：[no] tunnel source <ipv4-daddress>
Function：
Configure tunnel source.
Parameter：
is the ipv4 address of tunnel source
Command Mode：
Tunnel Configuration Mode
Default Situation：
None
Usage Guide：
None
Example：
Configure tunnel source IPv4 address 202.89.176.6
Switch {Config-if-Tunnel1}#tunnel source 202.89.176.6
9.2.2.3.1.16 tunnel destination
Command：[no] tunnel destination <ipv4-daddress>
Function：
Configure tunnel destination.
Parameter：
is the ipv4 address of tunnel destination
Command Mode：
Tunnel Configuration Mode
Default Situation：
None
Usage Guide：
None
Example：
Configure tunnel destination 203.78.120.5
Switch {Config-if-Tunnel1}#tunnel destination 203.78.120.5
9.2.2.3.1.17 tunnel nexthop
Command：[no] tunnel nexthop <ipv4-daddress>
Function：
Configure tunnel next hop.
Parameter：
is the ipv4 address of tunnel next hop.