Accton Technology ES4626 - Manual (Page 695)

695
2) Configure interface as PIM-SM domain boundary
（ 2） Configure PIM-SM global parameters
1) Configure switch as candidate BSR
2) Configure switch as candidate RP
3) Configure static RP
3、 Shut down PIM-SM Protocol
1. Start PIM-SM Protocol
It’s easy to make basic configuration of the PIM-SM routing protocol in EDGECORE
layer 3 switch, only need to turn on PIM multicast switch in Global Mode and turn on
PIM-SM switch on relevant interface.
Command Explanation
Global Mode
[no] ipv6 pim multicast-routing
Enable PIM-SM Protocol on each interface
(but below commands are required to really
start PIM-SM protocol on the interface), and
the NO operation of this command shuts
PIM-SM Protocol on all interfaces. (Required)
And then turn on PIM-SM switch on the interface
Command Explanation
Port Configuration Mode
[no] ipv6 pim sparse-mode
[passive]
Start PIM-SM Protocol of the interface. The
NO operation of this command shuts the
PIM-SM Protocol of this interface.
(Required)
2. Configure PIM-SM Auxiliary Parameters
（1）Configure PIM-SM Interface Parameters
1） Configure PIM-SM hello message interval time
Command Explanation
Port Configuration Mode
Ipv6 pim hello-interval < interval>
no ipv6 pim hello-interval
Configure interface PIM-SM hello message
interval time; the NO operation of this
command restores the default value.
2） Configure PIM-SM hello message holdtime
Command Explanation
Port Configuration Mode