Accton Technology ES4626 - Manual (Page 459)

459
Usage Guide: The LSA ages with time in the layer 3 switches, but not in the network
transmitting process. By adding the transit-delay prior to sending the LSA, the LSA will
be sent before aged
Example: Set the LSA transmit delay of interface vlan1 to 3 seconds.
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf transmit-delay 3
13.6.3.30 max-concurrent-dd
Command: max-concurrent-dd
no max-concurrent-dd
Function: This command set the maximum concurrent number of dd in the OSPF
process; the “no max-concurrent-dd” command restores the default
Parameter: <value> ranges between <1-65535>, which is the capacity of processing the
concurrent dd data packet
Default:
Not set, no concurrent dd limit
Command Mode: OSPF protocol mode
Usage Guide: Specify the max concurrent number of dd in the OSPF process
Example: Set the max concurrent dd to 20
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#max-concurrent-dd 20
13.6.3.31 neighbor
Command: neighbor A.B.C.D [| priority | poll-interval ]
no neighbor A.B.C.D [| priority | poll-interval ]
Function: This command configures the OSPF router connecting NBMA network. the “no
neighbor A.B.C.D [| priority | poll-interval ] ” command
removes this configuration fs
Parameter: <COST>,
OSPF neighbor cost value ranging between 1-65535; priority
, neighbor priority defaulted at 0 and ranges between 0-255; poll-interval
, 120s by default, which the polling time before neighbor relationship come into
shape , ranging between 1-65535
Default: No default configuration
Command Mode: OSPF protocol mode
Usage Guide: Use this command on NBMA network to configure neighbor manually.
Every known non-broadcasting neighbor router should be configured with a neighbor
entry. The configured neighbor address should be the main address of the interface. The