Accton Technology ES4626 - Manual (Page 425)

425
[no] offset-list
|access-list-name> {in|out}
[]
Configure that provide a deviation value to the
route metric value when the port sends or
receives RIPng data packet; the [no]
offset-list
|access-list-name> {in|out}
[]
command removes the deviation table
3）configure and apply route filter and route aggregation
Command Explanation
Router configuration mode
[no] distribute-list {<
access-list-number
|access-list-name > |
prefix} {in|out}
[]
Set to filter the route when the interface
sends and receives RIPng data packets.
The [no] distribute-list {<
access-list-number |access-list-name > |
prefix} {in|out}
[] command means do not set the
route filter
[no]aggregate-address
Configure route aggregation, the
[no]aggregate-address
command cancels the route aggregation.
4）configure split horizon
Command Explanation
Interface configuration mode
IPv6 rip split-horizon [poisoned]
Configure that take the split-horizon when the
port sends data packets, poisoned means
with poison reverse
no IPv6 rip split-horizon Cancel the split-horizon.
(3) Configure other RIPng protocol parameters
1）Configure timer for RIPng update, timeout and hold-down
Command Explanation
Router configuration mode
timers basic
no timers basic
Adjust the renew, timeout and garbage
recycle RIPng timer, the no timers basic
command restore the default configuration