Accton Technology ES4626 - Manual (Page 434)

434
1970/01/01 21:15:09 IMI: RECV[Ethernet1/10]: Receive from
[fe80::20b:46ff:fe57:8e60]:521
1970/01/01 21:15:09 IMI: RECV[Ethernet1/10]: 3000:1:1::/64 is filtered by access-list
dclist
1970/01/01 21:15:09 IMI: RECV[Ethernet1/10]: 3ffe:1:1::/64 is filtered by access-list dclist
1970/01/01 21:15:15 IMI: RECV[Ethernet1/2]: Receive from [fe80::203:fff:fe01:257c]:521
13.5.5.1.2 show debugging ipv6 rip
Command: show debugging ipv6 rip
Function: Show RIPng debugging status for following debugging options: nsm
debugging, RIPng event debugging, RIPng packet debugging and RIPng nsm debugging
Command Mode: Any mode
Example: Switch# show debugging rip
RIP debugging status:
RIPng event debugging is on
RIPng packet detail debugging is on
RIPng NSM debugging is on
13.5.5.1.3 show ipv6 rip interface
Command: show ipv6 rip interface
Function:
Make sure the interface and line protocols is up,.
Command Mode: Any mode
Example: Loopback is up, line protocol is up
RIPng is not enabled on this interface
Vlan1 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IPv6 interface address:
3000:1:1::1/64
fe80::203:fff:fe01:429e/64
Displayed information Explanations
Vlan1 is up, line protocol is up Interface is Up
Routing Protocol: RIP The routing protocol running on the
interface is RIPng
Passive interface: Disabled Passive-interface disabled
Split horizon: Enabled with Poisoned
Reversed
The split horizon is enabled with poisoned
reversed on the interface.
IP interface address: IPv6 address of the interface