Accton Technology ES4626 - Manual (Page 424)

424
[no] neighbor
Specify the IPv6 Link-local address and
interface of the neighboring route needs
point-transmitting; the [no] neighbor
command cancels
the appointed router.
[no] passive-interface
Block the RIPng multicast on specified port
and the RIPng data packet is only
transmittable among Layer 3 switch
configured with neighbor. the [no]
passive-interface command
cancels the function
（2） Configure RIP routing parameters
1）configure route introduction (default route metric, configure routes of the other
protocols to be introduced in RIP)
Command Explanation
Router configuration mode
default-metric
no default-metric
Configure the default metric of distributed
route; the default-metric
no default-metric command restores the
default configuration 1
[no]redistribute {kernel
|connected| static| ospf| isis| bgp}
[metric<value>]
[route-map]
Redistribute the routes distributed in other
route protocols into the RIPng data packet;
the [no]redistribute {kernel |connected|
static| ospf| isis| bgp} [metric<value>]
[route-map]
command cancels the distributed route of
corresponding protocols
[no]default-information originate
Generate a default route to the RIPng
protocol; the [no]default-information
originate command cancels the feature.
2）Configure the route offset
Command Explanation
Router configuration mode