Accton Technology ES4626 - Manual (Page 542)

542
terms for the pass/filter/search
Example:
Switch(config)# ip extcommunity-list LN permit 100:10
13.8.3.38 label-switching
Command: label-switching
no label-switching
Function: Enable label switching
Parameter: is the route identification label which normally should be（AS
number or IP address）: digits, for example: 100:10.
Command Mode: Interface Mode
Usage Guide: Interfaces configured with this command is able to switch labels or else
the label packet may be missing
Example:
Switch(config)#inter vlan 1
Switch(Config-If-Vlan1)#label-switching
Switch(Config-If-Vlan1)#
13.8.3.39 mpls enable-all-interfaces
Command: mpls enable-all-interfaces
Function: Enable label switching on all interfaces
Parameter: None
Command Mode:
Global mode
Usage Guide: Use enable-all-interfaces to enable label switching on all interfaces which
is equal to applying label-switching command on all interfaces.
Example:
Switch(config)# mpls enable-all-interfaces
Relevant Commands: mpls disable_all_interfaces, label-switching, no
label-switching
13.8.3.40 mpls disable-all-interfaces
Command: mpls disable-all-interfaces
Function: Disable label switching on all interfaces
Parameter: None
Command Mode: Global mode
Usage Guide: The function of mpls disable-all-interfaces command is just opposite to
that of mpls enable-all-interfaces command, which is just equal to applying no
label-switching command on all interfaces