Accton Technology ES4626 - Manual (Page 348)

348
ES4624-SFP/ES4626-SFP switch implements SNTPv4 and supports SNTP client unicast
as described in RFC2030; SNTP client multicast and unicast are not supported, nor is the
SNTP server function.
11.2 Commands for SNTP
11.2.1 sntp server
Command: sntp server { | < server_ipv6_addr> } [version
]
no sntp server { | < server_ipv6_addr>}
Function: Configure the IPv4/IPv6 addresses and the version of the SNTP/NTP server;
the “no” form of this command cancels the configured SNTP/NTP server addresses.
Parameter ： is the IPv4 unicast address of the SNTP/NTP
server,<server_ipv6_addr> is the IPv6 unicast address of the SNTP/NTP
server, is the version No. of the SNTP on current server,ranging between
1-4 and defaulted at 1.
Default:
No sntp/ntp configured by default.
Command Mode: Global Mode
Example:
(1) Configure an IPv4 address of a SNTP/NTP server. SNTPv4 version is adopted on
the server
Switch(Config)#sntp server 10.1.1.1 version 4
(2) Configure a SNTP/NTP server IPv6 address
Switch(Config)#sntp server 3ffe:506:1:2::5
11.2.2 sntp poll
Command: sntp poll
no sntp poll
Function:
Sets the interval for SNTP clients to send requests to NTP/SNTP; the “no
sntp poll ” command cancels the polltime sets and restores the default setting.
Parameters: < interval> is the interval value from 16 to 16284.
Default: The default polltime is 64 seconds.
Command mode: Global Mode
Example: Setting the client to send request to the server every 128 seconds.
Switch#config