4 ip igmp limit, 5 ip igmp join-group – Accton Technology ES4626 User Manual
Page 675
675
Default:
1000ms
Command Mode:
Interface Configuration Mode
Example:
Configure interface vlan1 IGMP last-member-query-count to 2000.
Switch (Config)#int vlan 1
Switch (Config-if-vlan1)#ip igmp last-member-query-interval 2000
16.6.3.4 ip igmp limit
Command: ip igmp limit
no ip igmp limit
Function:
Configure limit IGMP state-count on interface; the “no ip igmp limit”
command cancels the value of user manual configuration, and restores default value.
Parameter:
is maximum IGMP state reserved by interface, range from 1
to 65000
Default:
0, no limit.
Command Mode:
Interface Configuration Mode
Usage Guide:
After configuring maximum state state-count, interface only saves states
which are not more than state-count groups and sources. If it reaches upper limit of
state-count, it does not deal with when receiving related new group member identity
report. If it has saved some IGMP group states before configuring the command, it
deletes all of the states, and then immediately transmits IGMP general query to collect
the member identity report which is not more than state-count group. Static state and
static source are not in the limit
Example:
Configure interface vlan1 IGMP limit to 4000.
Switch (Config)#int vlan 1
Switch (Config-if-vlan1)#ip igmp limit 4000
16.6.3.5 ip igmp join-group
Command: ip igmp join-group <A.B.C.D >
no ip igmp join-group <A.B.C.D >
Function:
Configure interface to join some IGMP group; the “no ip igmp join-group”
command cancels this join
Parameter:
is group address
Default:
Do not join
Command Mode:
Interface Configuration Mode
Usage Guide:
When the switch is the HOST, the command configures HOST to join
some group; that is, if configuring the interface join-group 224.1.1.1, it will transmit IGMP
member report including group 224.1.1.1 when the switch receives IGMP group query
transmitted by other switches. Carefully, it is the diffence between the command and ip