Accton Technology ES4626 - Manual (Page 156)

156
otherwise, the group will be deleted.
Parameters:
is the group number of a port channel from 1 to 8, if
the group number is already exist, an error message will be given. dst-mac performs
load balancing according to destination MAC; src-mac performs load balance according
to source MAC; dst-src-mac performs load balancing according to source and
destination MAC; dst-ip performs load balancing according to destination IP; src-ip
performs load balancing according to source IP; dst-src-ip performs load balancing
according to destination and source IP. If a port group has formed a port-channel, the
load balance setting cannot be modified, please set the load balance mode before
port-channel.
Default: Switch ports do not belong to a port channel by default; LACP not enabled by
default.
Command mode: Global Mode
Example: Creating a port group and setting the default load balance method.
Switch(C onfig)# port-group 1
Delete a port group.
Switch(C onfig)#no port-group 1
4.3.3 port-group mode
Command: port-group mode {active|passive|on}
no port-group
Function: Adds a physical port to port channel, the “no port-group
“ removes specified port from the port channel.
Parameters: is the group number of port channel, from 1 to 8;
active
enables LACP on the port and sets it in Active mode; passive enables LACP on
the port and sets it in Passive mode; on forces the port to join a port channel without
enabling LACP.
Command mode: Interface Mode
Default: Switch ports do not belong to a port channel by default; LACP not enabled by
default.
Usage Guide: If the specified port group does not exist, a group will be created first to
add the ports. All ports in a port group must be added in the same mode, i.e., all ports
use the mode used by the first port added. Adding a port in “on” mode is a “forced” action,
which means the local end switch port aggregation does not rely on the information of the
other end, port aggregation will succeed as long as there are 2 or more ports in the group
and all ports have consistent VLAN information. Adding a port in “active” or “passive”
mode enables LACP. Ports of at least one end must be added in “active” mode, if ports of
both ends are added in “passive” mode, the ports will never aggregate.