Accton Technology ES4626 - Manual (Page 701)

701
Example: Configure to ignore RP priority.
Switch(config)#ipv6 pim ignore-rp-set-priority
17.2.3.9 ipv6 pim jp-timer
Command: ipv6 pim jp-timer <value>
no ipv6 pim jp-timer
Function: Configure to add JP timer. no ipv6 pim jp-timer restores the default value.
Parameter: <value> ranges from 10 to 65535
Default:
60s
Command Mode: Global Mode
Usage Guide: Configure the interval of transmitting J/P messages to59s.
Example: Switch(config)#ipv6 pim jp-timer 59
17.2.3.10 ipv6 pim multicast-routing
Command: ipv6 pim multicast-routing
no ipv6 pim multicast-routing
Function: Enable PIM-SM globally. The “no ipv6 pim multicast-routing” command
disables PIM-SM globally.
Parameter: None
Default: Disabled PIM-SM protocol
Command Mode: Global Mode
Usage Guide: Inspect the changing information about pim state by this switch..
Example:
Enable PIM-SM globally.
Switch (Config)#ipv6 pim multicast-routing
17.2.3.11 ipv6 pim neighbor-filter
Command: ipv6 pim neighbor-filter cess-list-name>
no ipv6 pim neighbor-filter cess-list-name>
Function: Configure the neighbor access-list. If filtered by the lists and connections with
neighbors are created, this connections are cut off immediately. If no connection is
created, this connection can’t be created.
Parameter: cess-list-name> is the applying access-list’ name
Default: No neighbor filter configuration
Command Mode: Interface Configuration Mode
Usage Guide: ACL’s default is DENY. If configuring access-list 1,access-list 1’s default is
deny. In the following example, if “permit any” is not configured, deny 10.1.4.10 0.0.0.255
is the same as deny any. The command can configure on IPv6 tunnel interface, but it is
successful configuration to only configure tunnel carefully.