Accton Technology ES4626 - Manual (Page 815)

815
Switch (Config-Router-Vrrp)# disable
20.3.5 enable
Commands: enable
Function : Activates VRRP
Parameters: N/A.
Default : Not configured by default.
Command mode : VRRP protocol configuration mode
Usage Guide : Activates the appropriate Virtual Router. Only a router (or L3 Ethernet
switch) interface started by this enable command is part of Standby cluster. VRRP virtual
IP and interface must be configured first before starting Virtual Router.
Example : Activating the Virtual Router of number 10
Switch(config)# router vrrp 10
Switch(Config-Router-Vrrp)# enable
20.3.6 interface
Commands: interface{IFNAME | Vlan <ID>}
no interface
Function
: Configures the VRRP interface
Parameters: interface{IFNAME | Vlan <ID>} stands for the interface name.
Default : Not configured by default.
Command mode : VRRP protocol configuration mode
Usage Guide : This command adds a layer 3 interface to an existing Standby cluster. The
"no interface" command removes the L3 interface from the specified Standby cluster.
Example
: Configuring the interface as "interface vlan 1"
Switch(Config-Router-Vrrp)# interface vlan 1
20.3.7 preempt-mode
Commands: preempt-mode{true| false}
Function : Configures the preemptive mode for VRRP
Parameters : N/A.
Command mode : VRRP protocol configuration mode
Default : Preemptive mode is set by default
Usage Guide
: If a router (or L3 Ethernet switch) requiring high priority needs to
preemptively become the active router (or L3 Ethernet switch), the preemptive mode
should be enabled.