Accton Technology ES4626 - Manual (Page 734)

734
Usage Guide: It is recommended to use default value and if layer 3 MLD is in operation,
please make this configuration in accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query- robustness 3
17.4.3.12 ipv6 mld snooping vlan suppression-query-time
Command: ipv6 mld snooping vlan <vlan-id> suppression-query-time <value>
no ipv6 mld snooping vlan <vlan-id> suppression-query-time
Function:
Configure the suppression query time; the “no” form of this command restores
the default value.
Parameter: vlan-id : vlan id, valid range: <1-4094>
value：query interval, valid range: <1-65535>secs.
Command Mode: Global Mode
Default: 255s
Usage Guide: This command can only be configured on L2 general querier. The
Suppression-query-time represents the period the suppression state maintains when
general querier receives queries from layer 3 MLD within the segment. To use this
command, the query-intervals in different switches within the same segment must be in
accordance. It is recommended to use the default value.
Example:
Switch(config)#ipv6 mld snooping vlan 2 suppression-query-time 270
17.4.3.13 show ipv6 mld snooping
Command: show ipv6 mld snooping [vlan <vlan-id>]
Parameter: <vlan-id> is the number of vlan specified to display the MLD Snooping
messages
Command Mode: Admin Mode
Usage Guide: If no vlan number is specified, it will show whether the global MLD
snooping is enabled and layer 3 multicast protocol is running, as well as on which vlan
the mld snooping is enabled and configured l2-general-querier. If a vlan number is
specified, the detailed MLD Snooping messages of this vlan will be displayed.
Example:
Summary of the switch MLD snooping
Switch(config)#show ipv6 mld snooping
Global mld snooping status: Enabled
L3 multicasting: running
Mld snooping is turned on for vlan 1(querier)
Mld snooping is turned on for vlan 2