Accton Technology ES4626 - Manual (Page 203)

203
disables Voice VLAN function on the port
Parameter:
None
Command Mode: Port Mode
Default: Voice VLAN is enabled by default
Usage Guide: When voice equipment is added to the Voice VLAN, the Voice VLAN is
enabled globally by default. This command disables Voice VLAN on specified port to
meet specified application of the user.
Example: Disable the Voice VLAN function on port3
Switch#config
Switch(config)#interface ethernet 4/3
Switch(Config-If-Ethernet4/1)#no switchport voice-vlan enable
5.6.2.2.3 voice-vlan
Command: voice-vlan mac <mac-address> mask <mac-mask> priority <priority-id>
[name <voice-name>]
no voice-vlan {mac > mask <mac-mask>|name
<voice-name> |all}
Function: Specify certain voice equipment to join in Voice VLAN; the "no" form of this
command will let the equipment leave the Voice VLAN
Parameter: Mac-address is the voice equipment MAC address, shown
in ”xx-xx-xx-xx-xx-xx” format; mac-mask is the last eight digit of the mask code of the
MAC address, the valid values are: 0xff, 0xfe, 0xfc, 0xf8, 0xf0, 0xe0, 0xc0,0x80, 0x0;
priority-id is the priority of the voice traffic, the valid range is 0–7; the voice-name is the
name of the voice equipment, which is to facilitate the equipment management; all
indicates all the MAC addresses of the voice equipments
Command Mode:
Global Mode
Default: This command will add a specified voice equipment into the Voice VLAN, if a non
VLAN labeled data packet from the specified voice equipment enters through the switch
port, then no matter through which port the packet enters, it will belongs to Voice VLAN.
The command will not interfere with the packets of VLAN labels.
Example: Add the 256 sets of voice equipments of the R&D department with MAC
address ranging from 00-03-0f-11-22-00 to 00-03-0f-11-22-ff to the Voice VLAN
Switch#config
Switch(config)#voice-vlan vlan 100
Switch(config)#voice-vlan mac 00-03-0f-11-22-00 mask 255 priority 5 name test
5.6.2.2.4 voice-vlan vlan
Command: voice-vlan vlan <vlan-id>
no voice-vlan