Accton Technology ES4626 - Manual (Page 286)

286
3. IPv6 Tunnel Configuration
（1）Add/Delete tunnel
Command Admin Mode
Global mode
[no] interface tunnel <tnl-id>
Create a tunnel. The NO command deletes a
tunnel.
（2） Configure tunnel source
Command Admin Mode
Tunnel Configuration Mode
[no] tunnel source
<ipv4-daddress>
Configure tunnel source end IPv4 address.
The NO command deletes the IPv4 address
of tunnel source end.
（3） Configure Tunnel Destination
Command Description
Tunnel Configuration Mode
[no] tunnel destination
<ipv4-address>
Configure tunnel destination end IPv4
address. The NO command deletes the IPv4
address of tunnel destination end.
（4） Configure Tunnel Next-Hop
Command Description
Tunnel Configuration Mode
[no] tunnel nexthop
<ipv4-daddress>
Configure tunnel next-hop IPv4 address. The
NO command deletes the IPv4 address of
tunnel next-hop end.
（5） Configure Tunnel 6to4 Relay
Command Explanation
Tunnel Configuration Mode
[no] tunnel 6to4-relay
<ipv4-daddress>
Configure 6to4 tunnel relay IPv4 address. The
NO command deletes the IPv4 address of
6to4 tunnel relay.
（6） Configure Tunnel Mode
Command Explanation
Tunnel Configuration Mode