Accton Technology ES4626 - Manual (Page 563)

563
Default: 4.
Command Mode: BGP route mode
.
Usage Guide: Only version 4 is supported so far, so whatever the configuration is the
version remains at 4.
Example:
Switch(config-router)#neighbor 10.1.1.66 version 4
Switch(config-router)#
13.8.3.80 neighbor weight
Command: neighbor {|} weight <0-65535>
no neighbor {|} weight [<0-65535>]
Function: Configure the route weight sent from the partner. The “no neighbor
{|} weight [<0-65535>] ” command restores the default value
Parameter: : Neighbor IP address
: Name of IP address
<0-65535>: Weight
Default: The default weight acquired from other routers is 0. The default weight on the
local static configuration is 32768
Command Mode: BGP route mode .
Default: The default weight acquired from other routers is 0. The default weight on the
local static configuration is 32768
Usage Guide: The path selecting can be affected through the configuration of the weight.
The weight is only relevant to the router which is not an attribute transmittable to outside.
Example:
Switch(config-router)#neighbor 10.1.1.66 weight 500
13.8.3.81 network (BGP)
Command: network [route-map ] [backdoor]
no network [route-map ] [backdoor]
Function:
Configure the BGP managed network, the route map specified in network
application, or set the “back door” for the network. the “no network
[route-map ] [backdoor] ” command cancels this configuration
Parameter: : Network prefix identifier
: Name of route-map
Default: None
Command Mode: BGP route mode .
Usage Guide:
As for BGP routes, specify the route through which the BGP
advertisements go. With the network defined by this command, the peer will be spreader