Accton Technology ES4626 - Manual (Page 526)

526
neighbor {|}
route-server-client
no neighbor {|}
route-server-client
Route server may configure BGP
neighbors under EBGP environment to
reduce the number of peers that every
client has configured; format “no” of the
command configures this router as route
server and specify the clients it serves,
the no neighbor {|}
route-server-client command can delete
clients.
17． Configure Path-selected rules
Command Explanation
BGP configuration mode
bgp always-compare-med
no bgp always-compare-med
bgp bestpath as-path ignore
no bgp bestpath as-path ignore
bgp bestpath compare-confed-aspath
no bgp bestpath
compare-confed-aspath
bgp bestpath compare-routerid
no bgp bestpath compare-routerid
bgp bestpath med {[confed]
[missing-is-worst]}
no bgp bestpath med {[confed]
[missing-is-worst]}
BGP may change some path-select rules
by configuration to change the best
selection and compare MED under EBGP
environment through these command,
ignore the AS-PATH length, compare the
confederation as-path length, compare
the route identifier and compare the
confederation MED etc. Its format “no”
recovers the default route path-selected
rules.
13.8.3 Commands for BGP
13.8.3.1 address-family
Command: address-family
Function:
Enter address-family mode
Parameter: : : address-family, such as IPv4、IPv6、VPNv4, etc
: sub address-family, such as unicast 、multicast.
Default: None
Command Mode: BGP routing mode
Usage Guide: Since the BGP-4 supports multi-protocol, it is available to get different
configuration for each address-family. Actually the configuration outside address-family