11 show ipv6 enable, 12 show ipv6 tunnel – Accton Technology ES4626 User Manual
Page 310
310
fragment, 0 fragment sent
Sent: 110 generated, 0 forwarded
0 dropped, 0 no route
IPv6 sent packets statistics
9.2.4.1.11 show ipv6 enable
Command：show ipv6 enable
Function：
Display IPv6 transmission function on/off status
Parameter：
None
Default：
None
Command Mode：
Admin Mode
Example：
Switch#show ipv6 enable
ipv6 enable has been on
Displayed information
Explanation
ipv6 enable has been on
IPv6 transmission switch is at on status
9.2.4.1.12 show ipv6 tunnel
Command：show ipv6 tunnel [
Function：
Display tunnel information.
Parameter：
Parameter tnl-id is tunnel No.
Default Situation：
None
Command Mode：
Admin Mode
Usage Guide：
If there is not tunnel number, then information of all tunnels are shown. If
there is tunnel number, then the detailed information of specified tunnel is shown.
Example：
Switch#show ipv6 tunnel
name mode source destination nexthop
tunnel3 6to4 178.1.1.1
Displayed information
Explanation
Name Tunnel
name
Mode Tunnel
type
Source
Tunnel source ipv4 address
Destination
Tunnel destination ipv4 address
Nexthop
Tunnel next hop (only applies to ISATAP tunnel)