6 cluster auto-add enable, 7 rcommand member, 8 rcommand commander – Accton Technology ES4626 User Manual
Page 847
847
or
belongs to. If this command is executed in a non-commander switch, an error will be
displayed.
Example:
In the commander switch, add the candidate switch which has the sequence
number as 17 and password as mypassword to the cluster.
Switch(config)#cluster member candidate-sn 17 password mypassword
22.1.3.6 cluster auto-add enable
Command: cluster auto-add enable
no cluster auto-add enable
Function:
When this command is executed in the commander switch, the newly
discovered candidate switches will be added to the cluster as a member switch
automatically; the “no cluster auto-add enable” command disables this function.
Command mode:
Global Mode
Default:
This function is disabled by default. That means that the candidate switches are
not automatically added to the cluster.
Instructions:
When this command is executed in the commander switch and the
commander switch receives the cluster register packets sent by the new switch, the
commander switch adds the candidate switch to the cluster. If this command is executed
in a non-commander switch, an error will be displayed.
Example:
Enable the auto adding function in the commander switch.
Switch(config)#cluster auto-add enable
22.1.3.7 rcommand member
Command: rcommand member
Function:
In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter:
is the cluster ID of the member switch, valid rang is 1 to 23.
Command mode:
Admin Mode
Instructions:
Enter the Admin Mode of the member switch and configure the member
switch remotely. Use “exit” to quit the configuration interface of the member switch. If this
command is executed in a non-commander switch, an error will be displayed.
Example:
In the commander switch, enter the configuration interface of the member
switch with mem-id 15.
Switch#rcommand member 15
22.1.3.8 rcommand commander
Command: rcommand commander