4 debug cluster packets, 5 debug cluster application, 6 debug cluster statemach – Accton Technology ES4626 User Manual
Page 852: 2 cluster administration troubleshooting
852
Usage Guide:
Executing this command on the switch will display the information of the
candidate member switches such as member ID, MAC address, IP address, equipment
name and type
22.1.5.1.4 debug cluster packets
Command: debug cluster packets {register |build |heartbeat } {in|out}
no cluster packets {register|build |heartbeat } {in|out}
Function:
Enable the debugging message of cluster admin receiving and sending
packets; the “no” form of this command disables the enabled debugging messages
Parameter: Register
displays a register packet of cluster administration. Build displays
join a cluster or delete packet from the cluster administration. Heartbeat packet for check
if cluster admin members are working properly; in parameter displays the debugging
messages related to the command or member switches receiving packets; out parameter
displays the debugging messages related to the command or member switches sending
packets
Command Mode：
Admin Mode
22.1.5.1.5 debug cluster application
Command：debug cluster application
no debug cluster application
Function
Display debugging message on data transmission between the switches when
the command
or member switch joins a cluster
Command Mode：
Admin Mode
22.1.5.1.6 debug cluster statemach
Command：debug cluster statemach
no debug cluster statemach
Function：
Enable the debugging message of the changes in member switches and
command switch direct protocol state machine when a cluster admin member joining the
cluster, the “no” form of this command disables the enabled debugging messages.
Command Mode：
Admin Mode
22.1.5.2 Cluster administration troubleshooting
When encountering problems in applying the cluster admin, please check the following
possible causes
z
If the command switch is correctly configured and the auto adding function (cluster
auto-add enable) is enabled. If the ports connected the command switch and member
switch belongs to Vlan1 (assumed to be in Vlan1 under current application)
z
Whether the connection between the command switch and the member switch is