2 address-family ipv4, 3 clear ip rip route – Accton Technology ES4626 User Manual
Page 398
398
Default:
No default configuration
Command Mode:
keychain-key mode
Usage Guide:
Refer to the 3.13 RIP authentication Introduction
Example:
The example below shows the accept-lifetime configuration of key 1 on the
keychain named mychain
Switch# config terminal
Switch(config)# key chain mychain
Switch(config-keychain)# key 1
Switch(config-keychain-key)# accept-lifetime 03:03:01 Dec 3 2004 04:04:02 Oct 6 2006
13.4.3.2 address-family ipv4
Command: address-family ipv4 vrf
no address-family ipv4 vrf
Function:
Configure this command to enable the routing message switching among VRF
and enter the address-family mode. The “no address-family ipv4 vrf
“ command deletes the RIP instances related to this VPN routing/forwarding
instances
Parameter:
specifies the name of VPN routing/forwarding instances
Command Mode: router mode
Usage Guide:
This command is only used on PE router. A VPN routing/forwarding
instances must be generated with command ip vrf prior to using this command by which
the VPN routing/forwarding instances can be related to RIP instances.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf VRF1
Switch(config-router-af)#
13.4.3.3 clear ip rip route
Command:clear ip rip route
{
Function:
Clear specific route in the RIP route table
Parameter:
Clear the routes which match the destination address from the RIP route
table.
address
kernel delete kernel routes from the RIP route table
static delete static routes from the RIP route table
connected delete direct routes from the RIP route table
rip only delete RIP routes from the RIP route table