Accton Technology ES4626 - Manual (Page 658)

658
consequently guarantee the transmission is processed in user-specified priority in the
entire network.
16.5.2 ECSCM Configuration Task List
1． Source Control Configuration
2． Destination Control Configuration
3． Multicast Strategy Configuration
1． Source Control Configuration
Source Control Configuration has three parts, of which the first is to enable source
control. The command of source control is as follows:
Command: Explanation
Global Configuration Mode
[no] ip multicast source-control
(Required)
Enable source control globally, the “no ip
multicast source-control ” command
disables source control globally. It is
noticeable that, after enabling source control
globally, all multicast packets are discarded
by default. All source control configuration can
not be processed until the it is enabled
globally, while source control can not be
disabled until all configured rules are
disabled.
The next is to configure the rule of source control. It is configured in the same
manner as for ACL, and uses ACL number of 5000-5009, every rule number can be used
to configure 10 rules. It is noticeable that these rules are ordered, the front one is the one
which is configured the earliest. Once the configured rules are matched, the following
rules won’t take effect, so rules of globally allow must be put at the end. The commands
are
Command Explanation
Global Configuration Mode