Accton Technology ES4626 - Manual (Page 687)

687
Parameter: None
Default:
Hello message includes Genid option
Command Mode: Interface Configuration Mode
Usage Guide : The command is used to interactive with old Cisco IOS Version.The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example: Configure hello messages transmitted by switch to exclude Genid option.
Switch(Config-if-Vlan1)#ipv6 pim exclude-genid
17.1.3.4 ipv6 pim hello-holdtime
Command: ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
Function: Configure and cancel Holdtime item value in Hello message, the value
describes neighbor overtime. If it goes over the time and does not receive hello message
of the neighbor, the register of the neighbor will be delete.
Parameter:
is configure time of holdtime.
Default: Define 3.5 times of Hello_interval, and default hello_interval as 30s, so default
value of hello_holdtime is 105s.
Command Mode: Interface Configuration Mode
Usage Guide: If no setting, hello time will default current 3.5 times of Hello_interval. If
setting hello time is less than current hello_interval, this setting will be declined. When
updating hello_interval every time, hello_holdtime will be also update based on these
rules below: if hello_holdtime does not be configured, or if hello_holdtime configured is
less than current hello_interval, hello_holdtime will be modified to 3.5 times Hello_interval,
otherwise, keeps configured value. The command can configure on IPv6 tunnel interface,
but it is successful configuration to only configure tunnel carefully.
Example: Configure hello holdtime setting on interface vlan1 to 10.
Switch (Config)# interface vlan1
Switch (Config -if-Vlan1)#ipv6 pim hello-holdtime 10
17.1.3.5 ipv6 pim hello-interval
Command: ipv6 pim hello-interval < interval>
no ipv6 pim hello-interval
Function: Configure interface PIM-DM hello message interval; the “no ipv6 pim
hello-interval ” command restores default value.
Parameter: < interval> is interval of periodly transmitted PIM-DM hello message, value
range from 1s to 18724s.
Default: Default interval of periodly transmitted PIM-DM hello message as 30s.