Accton Technology ES4626 User Manual
Page 396
396
version { 1 | 2 }
no version
Configure the versions of all the RIP data
packets transmitted/received by the Layer 3
switch port sending/receiving the no version
command restores the default configuration,
version 2.
（2）
Configure the RIP version to send/receive in all ports.
（3）
Configure whether to enable RIP packets sending/receiving for ports
Command Explanation
Interface configuration mode
ip rip send version { 1 | 1-compatible
| 2 }
no ip rip send version
Sets the version of RIP packets to send on all
ports; the no ip rip send version command
set the version to the one configured by the
version command
ip rip receive version {1 | 2 | }
no ip rip receive version
Sets the version of RIP packets to receive on
all ports; the no action of this command set
the version to the one configured by the
version command
ip rip receive-packet
no ip rip receive-packet
Enables receiving RIP packets on the
interface; the no ip rip receive-packet
command close data receiving on this port
ip rip send-packet
no ip rip send-packet
Enables sending RIP packets on the
interface; the “no ip rip send-packet”
command disables sending RIP packets on
the interface
4. Delete the specified route in RIP route table
Command Explanation
Privilleged mode
clear ip rip route
{
|rip|ospf|isis|bgp|all}
The command deletes a specified route from
the RIP route table
5. Configure the RIP VPN command.
Command Explanation
Router configuration mode