Accton Technology ES4626 User Manual
Page 163
163
Scenario 2: Configuring Port Channel in ON mode.
Fig 4-3 Configuring Port Channel in ON mode
Example: As shown in the figure, ports 1, 2, 3, 4 of SwitchA are access ports that
belong to vlan1. Add those four port to group1 in “on” mode. Ports 1, 2, 3, 4 of SwitchB
are access ports that also belong to vlan1, add the these four ports to group2 in “on”
mode.
The configuration steps are listed below:
SwitchA#config
SwitchA (Config)#interface eth 1/1
SwitchA (Config-Ethernet1/1)# port-group 1 mode on
SwitchA (Config-Ethernet1/1)#exit
SwitchA (Config)#interface eth 1/2
SwitchA (Config-Ethernet1/2)# port-group 1 mode on
SwitchA (Config-Ethernet1/2)#exit
SwitchA (Config)#interface eth 1/3
SwitchA (Config-Ethernet1/3)# port-group 1 mode on
SwitchA (Config-Ethernet1/3)#exit
SwitchA (Config-Ethernet1/4)# port-group 1 mode on
SwitchA (Config-Ethernet1/4)#exit
SwitchB#config
SwitchB (Config)#port-group 2
SwitchB (Config)#interface eth 1/1-4
SwitchB (Config-Port-Range)#port-group 2 mode on
SwitchB (Config-Port-Range)#exit
Configuration result:
Add ports 1, 2, 3, 4 of Switch 1 to port-group 1 in order, and we can see a group in
SwitchA
SwitchB